Electrical Instrument Calibration

We offer an Electrical Instrument Calibration Service for all makes and models of electrical test and measurement equipment. Our team of qualified technicians working in our in-house laboratory ensure that your electrical test instruments are performing as they should be and conform to all relevant manufacturer standards. We will issue you with a detailed calibration certificate outlining the calibration results of your equipment. All our lab certificates are traceable to national and international standards. With a delivery service available across Ireland and a typical 5 day turn around, we offer you a fast, reliable and competitive service for all your electrical test equipment calibration needs.

Electrical Instrument Calibration

We Can Perform Electrical Instrument Calibration on the following:

  • Digital Multimeters
  • PAT Testers
  • Multifunction Testers
  • RCD Testers
  • Loop Testers
  • Insulation Testers
  • LCR Meters
  • Decade Boxes/Time Resistance Boxes
  • Clamp Meters
  • Process Meters
  • mA/Loop Calibrators
  • PAT Calibration Checkboxes
  • Bench Top Multimeters
  • 5kv Insulation Testers
  • Milliohm Meters
  • Ground/Earth Testers
  • Calibration Checkboxes
  • Voltage Detectors
  • Socket Testers
  • Volt Sticks
  • Proving Units
  • Power Analysers
  • Scopemeters
  • Phase Rotation Equipment

All of our calibrations are carried out in accordance with Measurement Management System I.S. EN ISO 10012:2013.

If your device is not listed here simply contact us on 057 8662162 or email us and we will do our utmost to accommodate your request.

Details of some of the Electrical Instrument Calibration Tests Performed by us:

MULTIMETERSWe check functions such as operation, continuity beeper, diode check function and condition of test leads. We calibrate through all ranges on each function and all calibration specifications are taken from manufacturers manuals. We can detect any faults with your instrument and make adjustments where possible at no extra charge. If a repair service is required we will contact you to let you know what the additional charge required is. We calibrate and repair all makes of multimeter including Fluke, Megger, Kewtech, Robin, Iso-Tech and more.

CLAMPMETERS

Clampmeters are calibrated as multimeters and we can input AC and DC currents up to 2000A. Please note that all measurements have to be within manufacturers specifications to pass our calibration test.

MA LOOP CALIBRATORS/PROCESS METERS

These are very accurate instruments and we can simulate and read DC current and voltage to 25ppm which covers nearly all of these instruments.

PAT TESTERSWe test all functions of PAT Testers including Flash output up to 3kV. We also check earth bond leads to ensure they are not giving incorrect earth bond readings.We are also the only approved calibration lab in Ireland for the Seaward range of PAT Testers. This enables us to reset the calibration alarm and adjust calibration offsets where required.

MILLOHM/EARTH GROUND TESTERS

We can calibrate these instruments from 1milli ohm to kilo ohm values. We also check your test leads.

MULTIFUNCTION TESTERS

We offer a calibration and repair service to cover all functions of the Multifunction Testers. It is now a legal requirement that electricians have these instruments calibrated on an annual basis.

We can manage all your requirements as we calibrate all makes such as Robin, Fluke, Megger, Kewtech, DiLOg and many more.

For further information, email us or call us on 057 8662162, we would be happy to assist with any queries you might have.